Princeton-tec BOT Manuel d'utilisateur télécharger pdf

www.princetontec.com

ENGLISH

Figure 1 – Switch Operation

Opération de commutation Betriebsartenschalter

* Princeton Tec calculates total burn time as the time it takes for the light source to produce a

minimum of 0.25 lux at 2 meters. 0.25 lux is about the equivalent of a full moon on a clear night.

* Princeton Tec berechnet die Gesamtbrenndauer bezogen auf eine von der Stirnlampe erzeugte

minimale Beleuchtungsstärke von 0,25 Lux in 2 Meter Abstand. 0,25 Lux entsprechen in etwa

der Beleuchtungsstärke des Vollmonds in einer klaren Nacht.

* Princeton Tec définit la durée totale d’éclairage comme le temps nécessaire à la source

lumineuse pour produire un minimum de 0,25lux à 2mètres. 0,25lux équivaut à peu près à la

luminosité d’une pleine lune dans un ciel nocturne dégagé.

BOT

LED HEADLAMP

Operating and Maintenance

Instructions

Notice d’utilisation et d’entretien

Bedienungsanleitung

Battery Installation – See Battery Installation Diagram

• 2 AAA

• Alkaline (LR03) or Lithium

• Rechargeable NiCad or NiMH

Princeton Tec cares about the environment and

recommends recycling batteries. For more

information about battery recycling, please go

to: www.batteryrecycling.com

To install the batteries, open the battery door.

The battery door has a screw enclosure to

prevent accidental opening. The screw

requires a #1 Philips screwdriver for opening.

Once the screw is unsecured, rotate the

battery door open.

Install two (2) AAA batteries as shown in the

diagram. The tall spring on the battery door

should correspond with the negative polarity

and the shorter spring should correspond with

the positive polarity. Observe proper battery

polarity when installing the batteries. Improper

installation of the batteries will damage the light

and void the warranty.

Rotate the battery door to the closed position.

Using a #1 Philips screwdriver, secure the

battery door shut with the screw. Rotate the

screw down until secure.

WARNING

• Never mix fresh and used batteries.

• Never mix different battery brands or

chemistry types.

• Always remove drained batteries immediately.

• Remove batteries during long periods of

storage.

NOTE: Rechargeable NiCad or NiMH

batteries may result in reduced brightness

due to lower nominal voltage.

Switch Operation –

See Switch Operation diagram

The first button press turns the light on in low

mode. A second press activates high. A third

push activates the flash mode. Once a mode

has been selected for more than 2 seconds,

the next button press will turn the light off.

The Bot also has an auto shutoff function. After

2.5 hours of uninterrupted operation, the light

will turn itself off.

*The burn times listed on the rear of the

packaging assume you start with fresh

batteries, the light remains on, and you use

only one mode.

Troubleshooting

If the Bot fails to light:

• Check the batteries for proper installation.

• Replace batteries if proper installation is

confirmed.

• Check the light for water contamination on

the circuit board. The light will resume

normal operation once the water is shaken

or blown out and the light is left open until

completely dry. If the light has been

contaminated with salt water, flush the unit

with fresh water and dry as described above.

USA– International 5-Year Warranty

WARRANTY – Princeton Tec warrants this

product to be free from defects in workmanship

and materials under normal use for as long as

you own this product. This warranty covers all

of the component parts of the product except

batteries. This warranty does not cover

deterioration due to normal wear or damage

due to misuse, alteration, negligence,

accidents, or unauthorized repair. Princeton

Tec will repair or replace parts which are

defective in workmanship or materials.

Your authorized Princeton Tec Dealer and

Princeton Tec are the only facilities authorized

to repair the product. After (3) unsuccessful

attempts (within the warranty period) to repair

the product, you have the right to elect

replacement of the product or a refund of the

purchase price less allowance for use of the

product. NO INCIDENTAL OR CONSEQUEN-

TIAL DAMAGES ARE INCLUDED IN THIS

WARRANTY. (Some states do not allow the

exclusion or limitation of incidental or

consequential damages, so the above

limitations or exclusions may not apply to you.)

This warranty gives you specific legal rights,

and you may also have other rights which vary

from state to state.

Princeton Tec reserves the right to change

product specifications without notice.

Return Policy

If your light fails to operate, follow these

simple steps:

1) Check batteries. Replace if necessary.

2) Contact Princeton Tec customer service at

800-257-9080 to request an RMA number to

send your light in for repair or replacement. No

warranty repairs will be accepted without an

RMA number.

3) Return the light without batteries to:

Princeton Tec, 5198 Rt. 130, Bordentown,

NJ 08505. Postage due and freight collect

items will not be accepted.

Princeton Tec

PO Box 8057,

Trenton, NJ 08650

Phone: 609-298-9331

Fax: 609-298-9601

www.princetontec.com

To switch between light

sources, press and hold

button (1-2 seconds)

Figure 2 – Battery Replacement

Remplacement des piles Einlegen der Batterien

1 2

press 1x = Low

press 2x = High

press 3x = Flash

2 Ultrabright

LEDs

DISTANCE (Meters)

HIGH

4.5H

LOW

FLASH

11 H

1 2

Résumé du contenu

Page 1 - Figure 1 – Switch Operation

www.princetontec.comENGLISHFigure 1 – Switch OperationOpération de commutation Betriebsartenschalter* Princeton Tec calculates total burn time as the

Page 2 - Francais

FrancaisDeutschInstallation Des PilesVeuillez vous référer au diagramme d'installation des piles • 2 piles AAA • Alcaline (LR03) • Piles rech

Commentaires sur ces manuels

Pas de commentaire

Princeton-tec BOT Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Éclairage Princeton-tec BOT. Princeton Tec BOT User Manual [en] [fr] Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Éclairage Princeton-tec BOT