Princeton-tec FUEL Manuel d'utilisateur télécharger pdf

www.princetontec.com

ENGLISH

Figure 1 – Switch Operation

Opération de commutation Betriebsartenschalter

* Princeton Tec calculates total burn time as the time it takes for the light source to produce a

minimum of 0.25 lux at 2 meters. 0.25 lux is about the equivalent of a full moon on a clear night.

* Princeton Tec berechnet die Gesamtbrenndauer bezogen auf eine von der Stirnlampe erzeugte

minimale Beleuchtungsstärke von 0,25 Lux in 2 Meter Abstand. 0,25 Lux entsprechen in etwa

der Beleuchtungsstärke des Vollmonds in einer klaren Nacht.

* Princeton Tec définit la durée totale d’éclairage comme le temps nécessaire à la source

lumineuse pour produire un minimum de 0,25lux à 2mètres. 0,25lux équivaut à peu près à la

luminosité d’une pleine lune dans un ciel nocturne dégagé.

press 1x = High

press 2x = Med

press 3x = Low

press 4x = Flash

4 Ultrabright

LEDs

DISTANCE (Meters)

28 37

MED

90H

LOW

146H

HIGH

50H

FLASH

120H

FUEL

LED HEADLAMP

Operating and Maintenance

Instructions

Notice d’utilisation et d’entretien

Bedienungsanleitung

Figure 2 – Battery Replacement

Remplacement des piles Einlegen der Batterien

Med

Flash

146

Battery

Type

Low High

Power Level

Output

Distance (m)

Overall

Burn Time (Hours)

3 AAA

Alkaline

Cells

* The times listed in this chart

assume you start with fresh

batteries and use only one mode.

* Les durées mentionnées dans le

présent tableau sont calculées sur

la base de l’utilisation de piles

neuves et d’un seul mode d’éclairage.

* Bei den in der folgenden Tabelle

aufgeführten Zeiten wird

vorausgesetzt, dass Sie neue

Batterien und lediglich eine

Leuchtstärke verwenden.

Battery Installation – See Battery Installation Diagram

• 3 AAA

• Alkaline (LR03)

• Rechargeable NiCad or NiMH

Princeton Tec cares about the environment and

recommends recycling batteries. For more information

about battery recycling, please go to:

www.batteryrecycling.com

To install the batteries, use the tool on the headband to

unlatch the door. Open the Fuel case by popping the

door latch over the catch and rotate the door open.

Install three AAA batteries according to the polarity

markings on the inside of the cabinet. Observe proper

battery polarity when installing the batteries. Improper

installation of the batteries will damage the light and

void the warranty.

Rotate the door to the closed position, squeeze the

body between your forefingers and thumb to snap the

door latch over the catch.

WARNING

• Never mix fresh and used batteries.

• Never mix different battery brands or chemistry

types.

• Always remove drained batteries immediately.

• Remove batteries during long periods of storage.

NOTE: Rechargeable NiCad or NiMH batteries may

result in reduced brightness due to lower nominal

voltage.

Switch Operation – See Switch Operation diagram

Modes (High, medium, low and flash) are selected by

pressing and releasing the button within 1.5 seconds of

the previous button press.

There are two ways to turn the Fuel off. You can cycle

through the modes until you reach off, or if more than

two seconds has passed since the previous button

press the next press of the button will turn the light off.

Power Consumption

Refer to the burn time chart for performance data for

different battery types and mode settings.

**Princeton Tec calculates total burn time as the time it

takes for the light source to produce a minimum of 0.25

lux at 2 meters. 0.25 lux is about the equivalent of a full

moon on a clear night.

**The times listed in this chart assume you start with

fresh batteries and use only one mode.

Troubleshooting

If the Fuel fails to light:

• Check the batteries for proper installation.

• Replace batteries if proper installation is confirmed.

• Check the light for water contamination on the

circuit board. The light will resume normal

operation once the water is shaken or blown out

and the light is left open until completely dry. If the

light has been contaminated with salt water, flush

the unit with fresh water and dry as described

above.

USA– International 5-Year Warranty

WARRANTY – Princeton Tec warrants this product to

be free from defects in workmanship and materials

under normal use for 5 years. This warranty covers all

of the component parts of the product except batteries.

This warranty does not cover deterioration due to

normal wear or damage due to misuse, alteration,

negligence, accidents, or unauthorized repair.

Princeton Tec will repair or replace parts which are

defective in workmanship or materials.

Your authorized Princeton Tec Dealer and Princeton

Tec are the only facilities authorized to repair the

product. After (3) unsuccessful attempts (within the

warranty period) to repair the product, you have the

right to elect replacement of the product or a refund of

the purchase price less allowance for use of the

product. NO INCIDENTAL OR CONSEQUENTIAL

DAMAGES ARE INCLUDED IN THIS WARRANTY.

(Some states do not allow the exclusion or limitation of

incidental or consequential damages, so the above

limitations or exclusions may not apply to you.) This

warranty gives you specific legal rights, and you may

also have other rights which vary from state to state.

Princeton Tec reserves the right to change product

specifications without notice.

Return Policy

If your light fails to operate, follow these simple steps:

1) Check batteries. Replace if necessary.

2) Contact Princeton Tec customer service at

800-257-9080 to request an RMA number to send your

light in for repair or replacement. No warranty repairs

will be accepted without an RMA number.

3) Return the light without batteries to: Princeton Tec,

5198 Rt. 130, Bordentown, NJ 08505. Postage due

and freight collect items will not be accepted.

Princeton Tec

PO Box 8057,

Trenton, NJ 08650

Phone: 609-298-9331

Fax: 609-298-9601

www.princetontec.com

Use tool on headstrap to open battery compartment

Utilisez l'outil attaché à la sangle de la frontale pour

ouvrir le compartiment des piles.

Verwenden Sie zum Öffnen des Batteriefachs das

am Kopfband befestigte Werkzeug.

1 2

Résumé du contenu

Page 1 - Bedienungsanleitung

www.princetontec.comENGLISHFigure 1 – Switch OperationOpération de commutation Betriebsartenschalter* Princeton Tec calculates total burn time as the

Page 2 - Francais

FrancaisDeutschInstallation Des PilesVeuillez vous référer au diagramme d'installation des piles • 3 piles AAA • Alcaline (LR03) • Piles rech

Commentaires sur ces manuels

Pas de commentaire

Princeton-tec FUEL Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Éclairage Princeton-tec FUEL. Princeton Tec FUEL User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Éclairage Princeton-tec FUEL